Morbark 1600 Tub Grinder
  • + Expand All
  • - Close All
  • Specs - Discharging System

    Three 16” (40.64 cm) diameter augers discharging onto a 60” x 34” (152.4 cm x 10.36 m) heavy-duty belt conveyor

    Discharge height of 18” (5.48 m)


  • Specs - Hammermill and Screens

    43” x 69” (109.22 cm x 175.26 cm) hammermill opening with heavy-duty 28” (71.12 cm) diameter rotors, (16) 1-3/8” (3.49 cm) thick 2-piece rotor plates keyed on an 8-1/4” (20.95 cm) diameter rotor shaft with 5-3/16” (13.17 cm) bearings, (8) 2-1/2” (6.35 cm) hammer retaining rods.

    Hydraulic Rod Pusher

    Set of two 1” (2.54 cm) thick steel heavy-duty screens


  • Specs - Discharge System

    Three 16” (40.64 cm) diameter augers discharging onto a 60” x 34” (152.4 cm x 10.36 m) heavy-duty conveyor. Discharge height is 18” (45.72 cm).


  • Specs - General

    Length (transport): 49’8” (15.14 m)
    Length (operating): 68’10” (20.98 m)
    Height: 13’6” (4.11 m)
    Width: 12” (3.66 m)


    Gross weight: 101,080 lbs. (45,850 kg)
    Axle weight: 59,920 lbs. (27,180 kg)
    Tongue weight: 41,160 lbs. (18,670 kg)


    Engine: CAT
    Horsepower: 1,050 HP to 1,200 HP (782 kW to 895 kW)


    Fuel capacity (tank): 606 gallons (2,294 litres)
    Hydraulic oil capacity: 328 gallons (1,242 litres)


    Screen Area: 5,735 sq in (37,000 sq cm)


  • Specs - Tub

    Tub has 11’2” (3.4 m) diameter at inside base, 60” (152.4 cm) deep walls constructed of 3/8” (9.52 mm) reinforced steel plate, and floor constructed of 1/2” (12.7 mm) thick T-1 wear-resistant steel, supported by (16) roller guides carried on (8) 1-1/2” (3.81 cm) diameter chrome shafts and (8) 2” shafts.

    90-degree full tilt tub for easy access to hammermill with hydraulically powered variable RPM forward and reverse tub control; Morbark Integrated Control System tub controlled with automatic reversing tub, sensor system.

    Tub cover for debris containment

    Engine gauge panel and emergency shut-down system.

    Heavy-duty 12” (30.48 cm) tube frame with hydraulic stabilizer legs

    15” (4.57 m) diameter opening across the top


  • Specs - Options
    • Magnetized end pulley with collecting slide tray for ferrous metal removal
    • Morbark automatic reversing fan system
    • 11 HP auxiliary air compressor
    • Air compressor guard