• + Expand All
  • - Close All
  • Specs -  Discharge System
    • Two 14” (35.56 cm) diameter augers discharge onto a 36” (91.44 cm) belt conveyor
    • Discharge height: 15” (4.57 m)
    • Hydraulic fold for transport
    • Front hydraulic stabilizers and manual outriggers

  • Specs - Options
    • Variety of screens
    • Available with cab and loader
  • Specs - General

    Length (operating): 56’3” (17.14 m)
    Length (transport): 37’2” (11.33 m)
    Height (transport): 12’9” (3.88 m)
    Width: 11’2” (3.4 m)


    Gross weight NCL: 48,630 lbs. (22,058 kg)
    Axle weight NCL: 34,830 lbs. (15,800 kg)
    Tongue weight NCL: 13,770 lbs. (6,245 kg)
    Gross weight WCL (optional): 59,920 lbs. (27,180 kg)
    Axle weight WCL (optional): 40,540 lbs. (18,390 kg)
    Tongue weight WCL (optional): 19,380 lbs. (8,790 kg)


    Engine: CAT
    Horsepower: 800 HP (596 kW)


    Fuel capacity: 160 gallons (605 litres)
    Hydraulic oil capacity NCL: 120 gallons (454 litres)
    Hydraulic oil capacity WCL: 205 gallons (776 litres)


    Screen Area: 2,174 sq in (14,026 sq cm)


    Magnetized end pulley

    11-HP (8.2kW) air compressor

    Dust suppression system

    Morbark reversing fan

     


  • Specs - Hammermill and Screens

    24” x 52” (60.96 cm x 132.08 cm) Hammermill system constructed of heavy-duty 16-1/2” (41.91 cm) diameter laser-cut rotor, (13) 1-3/4” (4.44 cm) thick 2-piece laser-cut rotor plates to ensure precision and enforce steel strength. The plates are keyed on a 5-7/8”  (14.92 cm) diameter rotor shaft with 3-15/16” (10 cm) bearings direct driven at engine RPM and (8) 2” (5.08 cm) hammer retaining rods.

    Complete with (24) 2” (5.08 cm) balanced forged steel hard-surfaced hammers and (24) 2-15/16” (7.46 cm) replaceable inserts with nuts and bolts.

    1” (2.54 cm) thick wear form steel heavy-duty screens


  • Specs - Tub

    Tub has 9” (2.74 m) diameter at inside base, 62” (157.48 cm) deep walls constructed of 3/8” (9.52 mm) reinforced steel plate, and floor constructed of 1/2” (1.27 cm) thick wear-resistant steel, supported by 14 roller guides carried on 1-1/2” (3.81 cm) diameter shafts. Hydraulic full tilt tub for easy access to hammermill, with hydraulically powered variable RPM forward and reverse tub control; MICS (Morbark Integrated Control System) tub controlled with automatic reversing tub, sensor system. Tub cover for debris containment. Morbark Integrated Control System located in the instrument panel.